Sensor Bundle (HU31035) and Airbag Simulator Kit (HU31026)
This is a Automotive Sensor Simulator & Airbag Simulator Kit bundle which saves you $49.95!
The Automotive Sensor Simulator HU31035 ideal tool to simulate and actuate the output signal from automotive sensors: frequency, voltage, and test sequences.
The Sensor Simulator will help the technician in the diagnostic testing where many scan tool diagnostic ends. Will allow the technician to know if the failure is a faulty sensor, a defect in the wiring or a problem with the ECU itself. Eliminates need to replace non-defective sensors.
In SIMULATOR, one can use one the preset modes:
• Resistance simulation
• Voltage simulation
• Sine wave simulation
• Square wave simulation
• Temperature coefficient sensors (PTC & NTC)
• Throttle & pedal sensor simulation
• O2 sensor simulation
• Oxygen Lambda
• Exhaust gas pressure sensor simulation
• Camshaft position sensor (CMP) simulation
• Crankshaft position sensor (CKP) simulation
• Common rail pressure sensor
• Knock sensor simulation.
• Manifold absolute pressure (MAP) sensor.
• ABS sensor simulation
• Mass air flow (MAF) sensor simulation
• HVAC pressure sensor simulation
The HU31026 Airbag Simulator Resistor Reset Kit
HU31026 provides 5 resistors to properly replicate the OE factory airbag resistance.
Install the correct resistance simulators to replicate these components:
• Steering wheel airbag
• Passenger dash airbag
• Curtain airbag
• Side airbag
• Seat belt pretensioners
• Other components with a inflating airbag
California residents: Proposition 65 Information This product may contain chemicals, including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. Read more